Monday, March 18, 2013

How to set up and cast a new baitcaster

Fishing sales are in full swing up here...and I know a few of you probably have been toying with the idea of picking up a new reel for this season....maybe a baitcaster?  Baitcasters simply put can be very intimidating to the weekend angler...they are hard to cast...they definitely aren't spinning reels...and the ultimate fear of the dreaded "birds nest"...dum dum dummmm!

I remember last year returning something to Bass Pro, when I overheard a gentleman telling the employee at Bass Pro that his reel was broken.  I looked over and saw a baitcaster sitting on the counter.   The reel representative came over...toyed with it a few seconds, and said it was fine.  The gentleman tossed a confused look and didn't understand what was wrong.  Long story short...he didn't set up the reel correctly.  With a little up front work and some practice...this type of situation can be avoided, and there is less chance that you will toss the baitcaster to the side and forget about it.

Every baitcaster on the market today has several characteristics that need to be dialed in before you even make your first cast.  The drag, spool tension, and the braking system all need to be set to the lure that you are planning on throwing.

The drag star is located on the handle side, usually has 5 or 6 spokes and clicks when you turn it.  It is used to set the drag of the reel by applying more tension to the spool.   I usually turn it until it's snug and give it one  more 1/8 of a turn.  Some people run their drag a little loose, but for most applicatons around here you shouldn't have an issue running the drag tighter.

The spool tension is also found on the handle side and is usually a small cap or knob.  This knob puts tension on the spool when the spool is disengaged by the thumb bar.  With a lure tied on, and your rod tip about 8 o'clock you should set the spool tension so the lure falls slowly under its own weight.  Let the lure fall until it hits the ground...and the spool should stop spinning.  If the spool continues to spin, tighten it up a little bit more.


Now comes the most trivial part...the braking system.  Your reel comes with one braking system or two braking systems.  Magnetic braking systems are on the non handle side, and can be adjusted externally on the reel with a knob.   Magnetic brakes can be found in most Daiwa and Lews reels.  Centrifugal brakes are also on the non handle side of the reel and can be adjusted by taking off the non handle side plate of the reel.    Once the side plate is of there is usually a set of counter weights.  When the counter weights are pushed out...more braking.  When the counter weights are pushed in...less braking. Centrifugal brakes are usually found on Shimano and Quantum reels....with Quantum reels being the oddball because their centrifugal brake can be adjusted with a knob on the outside.  Some reels have both magnetic and centrifugal brakes...such as the Bass Pro Pro Qualifier, Lews Tournament Pro, Revo STX, and Pflueger Patriarch.




When you set up a brake system you always want to start with the braking system fully engaged.  So for magnetic brakes...that dial should be turned on as high as it can go.  With centrifugal brakes, the pins should all be pulled outward.  

Last thing you need to do is get your thumb ready to go....your thumb is the one thing that will eventually allow you to become great at using a baitcaster.  Train your thumb, and you will be less likely to rely on the braking system that the reel provides you.

Before you even go to cast for the first time you need to forget everything you have ever done with a spinning reel if that was your strength originally.   Baitcasting and spinning setups are two different animals and DO NOT cast the same.   Press the thumb bar and hold the spool with the thumb of your casting hand.  Let your thumb "feather" the line as the lure drops down to the ground.  Just as the lure is about to hit the ground, stop the spool with your thumb.  Repeat this several times until you get a feel for your thumb starting and stopping the lure.

Next you want to make a roll cast...or side arm cast.   Use your thumb to release and stop the spool as you already did above.  It is important to not let the rod tip "follow" your lure on the cast...try to keep the rod to the side of you during the cast....this will allow the bait to head straighter to your target.   Once you get a feel for this...you can start to dial back your brake system.   Turn the dial a few ticks back on the magnetic brake, or push two "opposite pins" inward to disengage them.   Centrifugal brakes you always want to disengage in pairs.  If you have a dual brake system....always start with the magnetic brake and work your way into the centrifugal brake.

Now comes the hardest part to learn...the overhand cast.  The mystery behind this cast is all in your release point and the follow through after.   When you release the bait your thumb should be coming off of the spool around the 11-12 o'clock position....and on the follow through your rod should hover around the 10 o'clock position.  You never want to follow the lure down in the follow through...or your lure will dive bomb right into the water....same will happen if you release late.

If you are just starting out I would recommend practicing with a cheap monofilament.  I know the temptation is there to jump into braided line because you heard it is easy to learn on....but I gaurantee you will not want to swallow a birds nest of 30 dollar braid.  Braid can be a bear to pick out on a bad birdsnest. 

Take your time, and be patient!  It took me 2 years to get pretty good with it, and I still get bad birdsnests every once in awhile.   But the reward in accuracy and casting distance will be worth it!  Had trouble in the past throwing heavy lures on spinning gear?  Won't be an issue anymore!

Good luck and tight lines!

Fluke

26 comments:

  1. Nice post. Definitely very accurate depiction of my (mis)adventures in learning how to use a baitcaster. I definitely recommend a light pound test mono be spooled on for beginners until they really get the hand of it. If someone had told me that I would have saved quite a bit of money on wasted fluorocarbon then braided line that I didn't need to. I find that the lower memory of lighter weight mono (say Trilene XL smoothcast 8-12lb test) is good to learn b/c of its low memory which results in lower tendency to nest up on you. Obviously that light of line is not what one would think of immediately when considering a bait caster, especially with the added stress on the line from fighting fish with the reel as opposed to the rod like in spin fishing, but I would still recommend this approach early until on gains greater confidence in their use of the baitcaster.

    ReplyDelete
  2. I always recommend mono at first...its cheap and does take a little more practice to cast. If you can learn to cast with mono...fluoro and braid will be a piece of cake.

    ReplyDelete
  3. Reels provide precise gearing and drag system for fishing. Stainless steel bearings, carbonate drag systems and anodized aluminum parts provide corrosion resistance and increased performance. 
    baitcasting reels

    ReplyDelete
  4. Buy hooks, accessories, delivery to USA: prices, reviews, features and equipment for them.
    baitcasting reels

    ReplyDelete
  5. Reels offer correct gearing and also pull technique with regard to doing some fishing. S / s bearings, carbonate pull systems and also anodized lightweight aluminum pieces offer deterioration . weight and also improved functionality.

    baitcasting reels

    ReplyDelete
  6. Reels produce correct gearing as well as get method regarding fishing. S / s bearings, carbonate get devices as well as anodized metal components produce deterioration . weight as well as greater efficiency.
    baitcasting reels

    ReplyDelete
  7. This comment has been removed by the author.

    ReplyDelete
  8. This is really a nice post and i was looking for something like this..thanks a lot

    Selecting best Commercial fishing gear

    ReplyDelete
  9. Technological know-how put together with accuracy management possesses moved Tica to become on the list of top sportfishing element companies which is ready to remain developing on this accomplishment, for more information click here baitcasting reel.

    ReplyDelete
  10. I agree with the majority of the points in this article and it’s great without any doubt. Really a wonderful post! I like it very much. Here I find everything in details. I hope I will see this type of post again in your blog
    baitcaster

    ReplyDelete
  11. Hi guys,
    Thank you so much for this wonderful article really!
    If someone want to know more about best baitcasting reel I think this is the right place for you!

    ReplyDelete
  12. Valuable blog and very interesting information about the fishing great work.
    khmer fishing

    ReplyDelete
  13. Thank you so much for this wonderful article really!
    If someone want to know more about Best Baitcasting Reel
    I think this is the right place for you!

    ReplyDelete
  14. This comment has been removed by the author.

    ReplyDelete
  15. This comment has been removed by the author.

    ReplyDelete
  16. Set up a baitcaster is a difficult task. Thank you so much for this kind of valuable article. I am also published some article on my website about Fishing reels. But this solution is the best one for setting up and cast a new baitcaster fishing reel.

    ReplyDelete
  17. This comment has been removed by the author.

    ReplyDelete
  18. Wonderful article, thanks for putting this together! This is obviously one great post. Thanks for the valuable information and insights you have so provided here.
    Rods & Reels

    ReplyDelete
  19. Hey ,
    Learn a lot from your write up. Very nice understanding with user. I have a little demand from you. Could you please share a post about best spinning reel under 50. I have looking for last 2 days but didn't find proper review about it. If you about it I'm appreciate with you.
    Cheers
    Bikash Roy

    ReplyDelete
  20. nice http://bassinthemidwest.blogspot.com/2013/03/how-to-set-up-and-cast-new-baitcaster.html

    ReplyDelete
  21. At present, the requirement for salmon fishing rods is incredibly higher because it is available in different kinds, plus these types of rods are generally robust, versatile, and long. The salmon fishing rods are also made for children. In the event you take a look at this https://lutasril.doodlekit.com/ internet site, you can obtain more info related to salmon fishing rods.

    ReplyDelete
  22. Best Bass Fishing Reels Thank you because you have been willing to share information with us. we will always appreciate all you have done here because I know you are very concerned with our.

    ReplyDelete
  23. Looking for the best baitcasting reel for bass? We've selected the 10 best casting reels on the market today. Budget conscious to premium selections.

    ReplyDelete
  24. Looking for the Best ultralight spinning reels? We've selected the 10 best casting reels on the market today

    ReplyDelete
  25. Great article I enjoy reading your thoughts. More power to your website. Please visit mine too
    Famous scientist

    ReplyDelete